PintyPlus Aqua Water Based Spray Paint - Assorted Colors
PintyPlus Aqua Spray Paint gives you a smooth, uniform, High Gloss on any type of surface. PintyPlus Aqua comes in a wide range of colors that are matched to the RAL color system, insuring consistent color from one can to another. The water based formula gives you an environmentally friendly, non-toxic, low odor alternative to traditional spray paints. PintyPlus Aqua is suitable for both indoor and outdoor use.
Ideal on wood, melamine, canvas, iron, plastic, cardboard and even glass. No aggressive solvents, means it's safe for use on expanded polystyrene. The environmentally friendly water-based formulation offers maximum coverage, fast drying and soap and water cleanup within the first 15 minutes.
- High Gloss Finish
- Wide Range of Decorator Colors
- Environmentally Friendly Water-Based Formula
- Faster Application, Gets in the Nooks and Crannies
- Better Coverage, as few as Two Coats
- Higher Yield, twice as much as Competitor Sprays
Performance 520cc/400ml = 15 sq. ft. (1.4 sq. m)
Drying time in 1 hour, total drying in 24 hour.
Repaint with PintyPlus Aqua colors in 5 minutes.
PintyPlus is a product of Novasol Spray S.A., a leading European manufacture of aerosol paints and sprays. Novasol Spray is committed to providing the best in quality, human-friendly products with minimal environmental impact.
Looking for project ideas, tips and tricks? Check out www.novasolsprayusa.com
How to apply:
The surface to be painted should be clean, dry and free of any contaminants.
Shake the can vigorously for 1 minute. Spray from a distance of 10 inches and apply in rapid thin layers, first horizontally and then vertically. To achieve a uniform coverage and avoid drips, apply in several thin layers instead of a thick one.
When you're finished spraying, invert the can and push the nozzle until only gas comes out. This will prevent clogging.
Questions? - Call us at 888-223-3050
Spray the product using the can in a vertical position.
Wait 5 minutes between layers. When the surface is dry to the touch, you are ready to apply the next layer.
If the nozzle clogs, clean with a cloth or rag and continue to paint normally.
If the surface to be painted is smooth, a light sanding will improve adhesion.
Remove any old loose paint with an appropriate paint stripper before painting.
Do not apply onto powered electrical equipment. Apply always in a well ventilated area.
Once empty, the aerosol should be disposed of according to local regulations.